Shopping cart

Your shopping cart is empty.

Prototype 2-axis Joint

Your rating: None (1 vote)

Experiments with corrugated card. We seem to have quite a lot of corrugated card lying around the house in the run up to the festive season. Time to put it to some use. I going to see if I can make a poseable model, first step, two axis joint to act as an arm/shoulder. The model is made entirely from corrugated card.


Check out the stop-motion of the joint in action.

The pins are made from rolled up corrugated card.


The shoulder/body pin is glued into place. The other pin is to the outer U-shaped piece.


The piece on the inside is glued to the pin so that it is free to rotate but not to pull out.

Log in or register to post review
< | >